Bostik's BEST

BEST  is a one-part, trowel-applied, tacking moisture-cure urethane adhesive. This advanced, scientifically-formulated adhesive does NOT contain water. Once cured, Bostik's Best is waterproof and is not adversely affected by exposure to moisture or water; its superior properties provide a tough, flexible, tenacious bond to a variety of surfaces. Bostik's Best's elastomeric characteristics allow the adhesive to move with the wood as it expands and contracts over the life of the floor.
 

BST Urethane

BST represents a breakthrough technology that offers exceptional physical and chemical properties for a urethane. BST is a one-part, trowel-applied, tacking moisture-cure urethane with unsurpassed green strength and ridge-holding capabilities. It trowels easily and, once cured, is not affected by moisture or water.




 

EFA+ (Elastomeric Flooring Adhesive)

Bostik's EFA is a one-part, trowel-applied, moisture-cure urethane adhesive that does NOT contain water. Once cured, EFA is waterproof and is not adversely affected by exposure to moisture or water. EFA's elastomeric characteristics allow the adhesive to move with the wood as it expands and contracts over the life of the floor.




 

Vapor-Lock? Wood Flooring Urethane Adhesive/Vapor-Retarding Membrane

Vapor-Lock? is a new and improved one-part, trowel-applied, rapid tacking, very low permeability moisture-cure urethane adhesive and vapor retarding membrane. This scientifically formulated adhesive/membrane does NOT contain water, is virtually odorless, and has 0%-VOC's.

Vapor-Lock offers a tenacious waterproof bond to a variety or substrates and is not adversely affected by exposure to moisture, water, or alkalinity; it can also create a vapor-retarding membrane designed to reduce moderate amounts of moisture vapor transmission from the subfloor and bridge cracks that can occur in the substrate prior to or after installation (up to 1/8?).






 

TKO Urethane (New and Improved) 0 VOC, 0 Solvent

Bostik's TKO is a one-part, trowel-applied, moisture-cure urethane; this advanced, scientifically-formulated adhesive does NOT contain water. Once cured, TKO is waterproof and is not adversely affected by exposure to moisture or water; its superior properties provide a tough, flexible, tenacious bond to a variety of surfaces. TKO's elastomeric characteristics allow the adhesive to move with the wood as it expands and contracts over the life of the floor.

A technical innovation in moisture-cure urethane adhesives that offers the following:

Easy to spread
Holds a better ridge
Cleans up faster when wet than most urethane adhesives
Contains Bostik's Blockade? Antimicrobial Protection
0-Solvent
0-VOC (as calculated per SCAQMD 1168)

 

MVP4? (Moisture Vapor Protection)

A one-part, trowel-applied, elastomeric, moisture-cure urethane membrane designed to:

1. Reduce Moisture Vapor Transmission from the subfloor
2. Create a Noise Reduction Barrier over the substrate, Peace   Noise Reduction
3. Establish an anti-fracture membrane that can bridge subfloor cracks up to 1/8" prior to or after installation

MVP4 contains Bostik Blockade? Antimicrobial Protection, which inhibits the growth of bacteria, mold, or mildew on the surface of the dried cement; the dried cement resists stains caused by mold.











 

Ultimate Adhesive Remover

Use Bostik's Ultimate Adhesive Remover to remove wet and cured urethane adhesive from the surface of pre-finished (non-wax) wood flooring. Ultimate Adhesive Remover is a readily-biodegradeable, low-odor, water-rinseable solution.

Bostik's Ultimate Adhesive Remover is available in two formulations: liquid and pre-soaked, ready-to-use towels.